3
INSERT
4 www . johnsonhardware . com
IF FRAME
ATTACH
1125
R
1060 SOFT CLOSE
Engage Soft Close Dampener by pushing Dampener trigger toward 3 Wheel Roller .
FOR USE WITH 100PD / 1500 / 1560 / 1562 / 2710 POCKET DOOR HARDWARE AND 100SD / 134F / 138F / 2610F SLIDING DOOR HARDWARE
100PD / 1500 / 1560 / 1562 / 2710 Pocket Door Instructions :
Instructions are for installing the 1060 Soft Close in a Pocket Door Frame using JOHNSON 100 Series Track . Minimum Door Thickness 1 " ( 25mm ) Soft Close or Soft Open only , Minimum Door Width 24 " ( 609mm ). Soft Close and Soft Open , Minimum Door Width is 28 " ( 711mm ).
Following steps are for soft close .
HANGER
LOCK
1 2
TABS UNLOCK
2-3 / 4 " ( 70mm )
3
2-3 / 4 " ( 70mm )
1121
IMPORTANT MUST BE ENGAGED
NO
SHOWN IN " ENGAGED " POSITION
|
" ENGAGED " POSITION
5D
|
6 |
HANG DOOR . |
LOCK |
7
SLIDE door away from end of track ( check to make sure all track screws are flat against track ) and install 1060 Actuator Arm into track , with back of Actuator Arm 2-1 / 4 " ( 57mm ) from Jamb . HAND TIGHTEN ( do not use power drill ) Actuator Arm on track Check to make sure Arm stayed straight in track . Slowly close door , checking to make sure door touches Jamb , if not . Slide door away from Jamb and readjust Actuator Arm . Slowly close door again , checking to make sure soft close is working properly . Once confirmed , begin using door normally .
2-1 / 4 " ( 57mm )
DOOR
2-3 / 4 " ( 70mm )
JAMB
IN1060SC L . E . JOHNSON PRODUCTS , INC . - 2100 STERLING AVE . - ELKHART , IN USA 46516 - ( 574 ) 293-5664 Rev 12 / 15